Dear all,

I have noticed a problem with my GUI applications (Ansys CFX, cfx5pre, etc).

Following protocol i wanted to use these applications via the "GUI"-dialogue nodes login18-x-1, login18-x-2. The application started but the part of the GUI which displays the 3D mesh, the 3D geometry or the 3D domain set up could not be displayed (it gave a glitch, showing only the fixed screen "behind" the GUI, when the GUI was loaded).

I am not very much bothered by this, since it works perfectly fine on login18-1, but i feel like im "abusing" the system, so i wanted to report this issue.

I case more information is required, because for the isse to show an actual case needs to be loaded in Ansys CFX, i can attach screenshots the next time.

Best Regards, Marek Simon